TechRxiv
Tiraxial Cable - Final.pdf (618.56 kB)

Optimization and Cold Test of a Triaxial 2G HTS Power Cable with High Current Capacity

Download (618.56 kB)
preprint
posted on 10.11.2020, 07:18 by Vitaly Vysotsky, Vasily Zubko, Sergey Fetisov, Alexander Nosov, Sergey Zanegin
Triaxial HTS AC power cables, that incorporates three HTS phases wound around a single core within a single cable is considering the optimal solution for low and medium voltages. Such a design permits to save expensive HTS conductor and to increase the power density transmitted. It is difficult to increase the transmission capacity of a triaxial cable by increasing its operating voltage and therefore, insulation thickness between phases. The other way is to increase the operation current by using a multilayer structure in each phase of the triaxial cable. This task demands a complicated optimization analysis and a precise manufacturing technology. Following our previous studies, we developed and tested the triaxial cable prototype with two layers per phase made of ReBCO wire. The optimal parameters of the cable (twist pitch, diameters of phases, etc.) have been determined using the numerical simulation methods developed. DC and AC tests of the cable has been performed. In the result, the feasibility to provide a uniform current distribution in a triaxial cable, each phase of which consists of two layers, has been demonstrated. With an outer diameter of ~24 mm only, this is the most compact triaxial HTS power cable manufactured and tested up to date with currents up to 4 kA per phase. The anticipated power transfer with three phases of this cable can be as large as ~34 MW.



Funding

This work is supported by the Russian Scientific Foundation under Grant №16-19-10563П.

History

Email Address of Submitting Author

vysotsky@ieee.org

ORCID of Submitting Author

0000-0003-4947-7072

Submitting Author's Institution

Russian Scientific R&D Cable Institute

Submitting Author's Country

Russian Federation

Licence

Exports

Licence

Exports