In this paper we present the lamination curing as a stand-alone method to activate the silver nanoparticle (Ag NP) inkjet printed angle sensors on a 0.14 mm PET substrate, with a desktop printer. (With the term “lamination curing”, we refer passing the printed sample through a lamination machine, without any actual laminating purpose, only for curing.) We compared the method with the oven curing, which is the widest used method for the intended sensors, and found that lamination cured sensors give lower sheet resistance, lower fabrication uncertainty and more consistent angle sensing behaviors with higher sensing performance. Different curing parameters are inspected and a process under 3 minutes is achieved giving a 0.06 Ohm/square sheet resistance. For such a low sheet resistance, presented method has the lowest thermal curing time among all single layer Ag NP printing studies in the literature. An experimental model is presented for the sheet resistance - aspect ratio relation for both methods. Time dependent resistance shifts of the lamination cured sensors are also inspected and proved to be insignificant. We state lamination curing as an advantageous and reliable alternative to oven curing and other fast curing methods both for sensor and circuitry printing implementations.