loading page

New Technique for Improving Modal Filter Performance by Using an Electromagnetic Absorber
  • Yevgeniy Zhechev ,
  • Adnan Alhaj Hasan ,
  • Konstantin Malygin
Yevgeniy Zhechev
Tomsk State University of Control Systems and Radioelectronics

Corresponding Author:[email protected]

Author Profile
Adnan Alhaj Hasan
Author Profile
Konstantin Malygin
Author Profile


This paper presents a novel technique for improving the performance of a modal filter by using an electromagnetic absorber. The study considers a two-conductor modal filter based on a microstrip transmission line. The authors analyzed the effect of the absorber on the MF performance in suppressing conducted and radiated interferences (in the near and far fields). The frequency characteristics of the device were then redefined into the time characteristics in the Advanced Design System. As an excitation, the authors used an ultra-wideband interference pulse of 155 ps (at 0.5 level) and then employed N-norms to estimate and characterize the decomposed pulses. The results show that the use of the absorber can significantly improve the attenuation of the ultra-wideband interference. It was experimentally demonstrated that the value of N1 decreased by a factor of 4.31, N2 – by a factor of 6.52, N5 – by a factor of 1.87. In terms of radiated interference in the near field, the improvement in attenuation of each norm achieved at least 2.81 times. The analysis of the characteristics in the far field showed that the use of the electromagnetic absorber allows reducing the transmission coefficient on average by 2.25 times at a distance of 1 m. To validate the measurement results, the electrodynamic simulation of the modal filter characteristics in the frequency range up to 6 GHz was carried out and showed full agreement with the experimental results.
2022Published in IEEE Access volume 10 on pages 86663-86670. 10.1109/ACCESS.2022.3199360